Simons Voss Technologies Palm LDB Version 1.40 Instalační manuál stáhnout pdf (Strana 166)

Smart Relay: SREL, SREL.ZK, SREL.ADV

Page 16

+ / ~

- / ~

COM

Brown

White

Green

Grey

Yellow

Batterie SREL.BAT

Netzteil

{

Relais

{

}

Externe Antenne

SREL.AV

V+ F3

Evtl. Widerstand zur

Leistungsbegrenzung.

Der Ausgang V+ liefert

max. 10 mA bei 3VDC

Entweder Buzzer oder LED

Possibly resistor for restricting power

The V+ output supplies a max. 10 mA at 3 VDC

7.13 Interface

Only for SREL.ADV

For operation as a serial interface, you can select the type of card reader here that

the Smart Relay should simulate. You have the following option’s:

 Wiegand 32 bit

 Wiegand 26 bit

 Primion

 Siemens

 Kaba Benzing

 Gantner Legic

 Isgus

You will find the corresponding cabling information in the chapter "The Smart Relay

as a Serial Interface".

7.14 Restricted range

If you select this option, the reader range from the transponder Æ Smart Relay is

restricted from approximately 1.5 m (4.9 ft) down to 0.4 m (1.3 ft). For example, you

can use this option if there are several Smart Relays close to one another and

individual transponders are authorised for several Smart Relays.

7.15 External Beeper/ External LED

Only for SREL.ADV

Normally, the Smart Relay is configured for connection to an LED. If you want to

connect a beeper or buzzer as the external signaller, mark this option. In this way, the

beeper/buzzer can be used for an acoustic acknowledgement, instead of the LED.

Should the connected component need less than 10 m maximum current at

3 VDC, the connecting plan can look as follows:

1 2 ... 161 162 163 164 165 166 167 168 169 170 171 ... 317 318

Komentáře k této Příručce

Žádné komentáře

Simons Voss Technologies Palm LDB Version 1.40 Instalační manuál Strana 166

Komentáře k této Příručce

Související produkty a manuály pro ne Simons Voss Technologies Palm LDB Version 1.40