Simons Voss Technologies Palm LDB Version 1.40 Instalační manuál stáhnout pdf (Strana 185)

Smart Output Module

Page 14

8.4 Adjust the Pulse Length

The modules appear in the locking plan as the locking type "expansion module". You

can select a pulse length from 0.1 to 25.5 seconds in the configuration for each

module. This length then applies to all of the module's outputs.

8.5 Select Signaling

Signaling is a special function where two of a module's outputs always work together.

The first output reacts completely normally, depending on transponder operation; the

output assigned to it simultaneously generates an alternating signal. You can select

this option, for example, if you want to have the keys that are released when an

elevator is controlled blink.

Attention: If you select this option, the number of outputs that are switched

when authorized is reduced from eight to four.

Output assignments for signaling:

1 Æ 5

2 Æ 6

3 Æ 7

4 Æ 8

8.6 Automatic Name Assignment in the Software

The SimonsVoss software automatically assigns designation to modules when the

modules are created. The following convention is used:

SMART RELAY NAME - MOD0 - OUT1

(z.B. Aufzug1-MOD0-OUT4)

8.7 Inverting the Outputs

This option allows the output switching behavior to be inverted. If there is no supply

voltage, all output relays are always closed.

Module

address:

0 to F

Output

number:

1 to 8

1 2 ... 180 181 182 183 184 185 186 187 188 189 190 ... 317 318

Žádné komentáře

Simons Voss Technologies Palm LDB Version 1.40 Instalační manuál Strana 185